5th piece:
the 6th piece, is too large and not level with 4th and 5th, which is not good for separating are on,
the final piece on top is a bit large and flatten
final one, with drawing on top, identifying the direction,
also draw the lines of the different pieces
and take out the board in the bottom, let it dry.
beginning to separate it, try to take the clay out, but that’s too tight
after a long time using a saw to cut the edge, first part come off~
keep cutting, hard work due to the lack of polishing each pieces surface!!!
finally done with some unexpected separate part, using rubber band to hold it, hope it’s fine
putting in the dry out cabinet:
wash with brush:
some improvement for next time:
1) use cooking spray on the surface of the model, or hair spray, just a layer
2) use thin and smooth sheet inserted into the mould, as seen on youtube, to make a better mould.
now….too much cracking (plaster not mixing well) and in the process of cutting off the mould…..so that the final piece casted out would need a lots of work to fine tune or sculpt.
Vinex2013 